By:
On:

Access the NAVLink 2 web interface and confirm it is the latest version as per the screen shot below…. Select the “Data Modes” page, set the NMEA Mode to “15 – RAW Mode” and click the “Update Settings” button… Ensure you get the Data Mode changed successfully message…. Now go to the “View Data” page and you will see data, similar to that shown below, scrolling down the screen… Now switch the “Start Log” button to ON and leave this page running for at least 15-20 minutes, so that we get a good selection of data. If there is a particular situation that causes aRead More →

By:
On:

If you need to disable the GNSS PGNs that the AIT2500/AIT5000 outputs then this is the procedure to follow…. Using the proAIS2 software, go to the Serial Data tab and then copy and paste the following commands in to the box at the bottom of the page and click the “Send” button (see image below). To disable GPS data output over NMEA 2000 send this command: $PSMT,0,3,0x2C75B2FA,1,n2kognss 0,0*15   To enable it again send this command: $PSMT,0,3,0x2C75B2FA,1,n2kognss -1,0*39     ….if the command was successfully received and actioned, you should see Transponder respond with… $PSMT,255……….etc.     (basically, the same as the command but 255 instead ofRead More →

By:
On:

This video will show you how to install our AIT5000 Class B+ AIS Transponder for NMEA 0183 & NMEA 2000 based systems. To configure the AIT5000, you need to configure the AIT5000 with its built-in web interface.Read More →