By:
On:

We have had a few of our dealers and customers successfully connect the Furuno DRS4W and our NAVLink2 together, so that you have one wireless network. The Furuno DRS4W must be the wireless Access Point and you have to tell our NAVLink2 to connect to the Furuno wireless network in Station mode – this is configurable in the NAVLink2 web interface SETTINGS page. When the NAVLink2 connects to the Furuno network, you will not know what IP address it has received, so it is important that you use UDP mode for receiving the NAVLink2 data, as this works without knowing the IP address – youRead More →

By:
On:

Applicable to 4GXtream units with NMEA 2000 interface   In order to direct the 4GXtream’s internal GPS data to it’s internal NMEA 2000 gateway, we must create a TCP network connection between the two devices.   In the 4GXtream’s web interface go to SERVICES>GPS>GENERAL and enable the settings as shown below and click SAVE & APPPLY… Now goto SERVICES>GPS>NMEA and setup the NMEA Forwarding as shown below…. Scroll further down the page and turn on the GPRMC sentence to be transmitted every 1 second and click SAVE & APPLY… Now goto SERVICES>SERIAL UTILITIES>OVER IP and Edit the iKonvert entry. Make sure that the iKonvert isRead More →

By:
On:

By default, Njordlink creates a wireless Access Point (hotspot) on-board your boat. The Name (SSID) of the Access Point will be “Njordlink-xxxx”, where xxxx is the unique four digit code of your device. To connect to the Njordlink WiFi, you will need to scan for wireless networks, find and select it in the network list and then when prompted, enter the default WPA2 password, which is “PASS-xxxx”, where xxxx is the same, unique four digit code that is in the hotspot name. For instance, if the WiFi network name created is Njordlink-D4B7 then the WiFi network password is: PASS-D4B7Read More →

By:
On:

Press and hold the reset button for 10 seconds.  You’ll see the LEDs illuminate in sequence and then reverse the sequence.  Release the reset button and NjordLINK will reboot and be returned to factory settings.Read More →