By:
On:

In the fast moving world of wireless technology, our WL510 is quite old now and you might get the message: “err_ssl_version_or_cipher_mismatch” when trying to upload the configuration file. This is due to the age of the firmware as V5.5.8 used TLS V1.0 which is no longer supported in most modern browsers. The way to get round this, is to use an older computer with an older browser on it. Once you have an older computer connected and can bring up the WL510 web interface, update the firmware to the latest version and the “err_ssl_version_or_cipher_mismatch” issue will be gone. The latest version of the WL510 firmwareRead More →

By:
On:

If you have followed the procedure to reset the WL510 then you must follow the procedure below to reconfigure the WL510. You must download the product firmware by clicking here.   Configuration Procedure – Wireless Method After a reset, the WL510 reverts to a factory defaults state and needs to have a WL510 Configuration file uploaded to it (link above). Your WL510 currently has a fixed IP address of 192.168.1.20 and is not providing Automatic DHCP IP address allocation to any devices that are connected to it. Your iNavConnect/iNavHub/iKConnect is trying to get an IP address for its WAN socket from the WL510 but isRead More →

By:
On:

If you have followed the procedure to reset the WL510 then you must follow the procedure below to reconfigure the WL510. You must download the product firmware by clicking here.   Configuration Procedure – Direct Cable Method After a reset the WL510 has a fixed IP address of 192.168.1.20 and does not provide IP addresses to devices that connect to it automatically. Therefore you will need to connect a PC or Mac to the WL510 using a normal network Ethernet cable and set the computer you are using to temporarily use a fixed IP address of…   Fixed IP address                 =             192.168.1.2   SubnetRead More →

By:
On:

First you need to unscrew the four black screws that hold the end cap of the WL510 in – the end cap with no connectors… Once the end cap is removed look down in to the unit and you will see the Reset switch which I have highlighted in the red box…. Here is another picture showing the PCB with the six LEDs in the red box and my finger pressing the reset switch…. With the WL510 powered up and the end cap removed, press and hold the reset switch for at least 15 seconds. You should see the reflection of the LEDs on theRead More →

By:
On:

To decide whether to use the Mobile 4G connection or the WL510 long range wireless connection, you will need to go in to the 4GXtream web interface and click on the Network>WAN menu option….which will display the page below. You can use the switches at the end of each line to select whether you want to connect to the internet via Mobile 4G or via the WL510 Wi-Fi on the wired WAN interface. In the screen shot above, taken from my boat’s 4GXtream, I do not have an WL510 wireless booster connected to the Wired WAN interface, so it does not show any information aboutRead More →